83530
1.INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.
Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
Do not apply adhesive to the oil inlet port of the engine oil pressure switch assembly.
Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly to the oil cooler cover sub-assembly.
Do not start the engine for at least 1 hour after the installation.
Connect the connector to the engine oil pressure switch assembly.
2.ADD ENGINE OIL
3.INSPECT FOR OIL LEAK
51442
4.INSTALL NO. 2 ENGINE UNDER COVER (for 4WD and Pre-Runner)