64271C
1.REMOVE BACK PANEL TRIM
62514A
2.REMOVE LOWER QUARTER TRIM PANEL LH
62513A
3.REMOVE LOWER QUARTER TRIM PANEL RH
62512
4.REMOVE QUARTER INSIDE TRIM BOARD LH
62511
5.REMOVE QUARTER INSIDE TRIM BOARD RH
81240
6.REMOVE NO. 1 ROOM LIGHT ASSEMBLY
62432C
7.REMOVE FRONT ROOF SIDE RAIL GARNISH LH
62431C
8.REMOVE FRONT ROOF SIDE RAIL GARNISH RH
63310
9.REMOVE ROOF HEADLINING ASSEMBLY
Remove a sufficient amount of the rear portion of the roof headlining assembly so that back window assembly removal and installation procedures can be performed.
Partially remove the roof headlining assembly.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>REMOVAL
64810
10.REMOVE BACK WINDOW ASSEMBLY (for Fixed Type)
Be careful not to damage the back window glass when cutting as the back window glass spacers are installed to the back window glass.
The back window glass may fall while performing this procedure. Therefore, use suction cups to hold the back window glass from the outside of the vehicle.
|
Protective Tape |
Put protective tape on the body panel around the back window assembly.
When separating the back window assembly from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.
| *a | Matchmarks |
When reusing back window assembly:
Place adhesive tape on the back window assembly and body panel and use a pen to place matchmarks for installation.
Install the suction cups to the back window assembly.
w/ Window Defogger System:
Disconnect the back window defogger connector.
| *1 | Back Window Glass Spacer |
| *2 | Back Window Glass Clip |
| *a | Piano Wire |
From the interior, insert a piano wire between the vehicle body and back window assembly as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.
Pull on the ends of the piano wire alternately and leave the back window assembly spacers and back window glass clips when cutting through the adhesive.
Do not forcefully brush the piano wire against the back window assembly.
Be careful as the piano wire will break if it crosses itself.
Using suction cups, remove the back window assembly.
Make sure that the back window assembly does not fall.
64810
11.REMOVE BACK WINDOW ASSEMBLY (for Slide Type)
The back window glass may fall while performing this procedure. Therefore, use suction cups to hold the back window glass from the outside of the vehicle.
|
Protective Tape |
Put protective tape on the body panel around the back window assembly.
When separating the back window assembly from the vehicle, be careful not to damage the vehicle paint or interior/exterior ornaments.
Using a knife, cut off the moulding as shown in the illustration.
Be careful not to damage the vehicle body.
| *a | Cut | - | - |
Install the suction cups to the back window assembly.
| *1 | Spacer |
| *2 | Clip |
| *a | Piano Wire |
From the interior, insert a piano wire between the vehicle body and back window assembly as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.
Pull on the ends of the piano wire alternately and leave the spacers and clips when cutting through the adhesive.
Do not forcefully brush the piano wire against the back window assembly.
Be careful as the piano wire will break if it crosses itself.
Using suction cups, remove the back window assembly.
Make sure that the back window assembly does not fall.