Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
45100
1.REMOVE STEERING WHEEL ASSEMBLY
55410C
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55900
3.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (WINDOW DEFOGGER SWITCH) (for Automatic Air Conditioning System)
|
Protective Tape |
Put protective tape around the air conditioning control assembly.
Detach the clip and remove the air conditioning control assembly.
Disconnect the connector.
Disconnect the cooler thermistor (room temperature sensor) connector.
Disconnect the air conditioning duct sub-assembly.
55905J
4.REMOVE CONTROL KNOB SUB-ASSEMBLY (for Manual Air Conditioning System)
55918A
5.REMOVE AIR INLET DAMPER CONTROL LEVER (for Manual Air Conditioning System)
84013A
6.REMOVE INTEGRATION PANEL SUB-ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Manual Air Conditioning System)
55906A
7.DISCONNECT DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
55909A
8.DISCONNECT AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
55908A
9.DISCONNECT AIR INLET DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
55905A
10.REMOVE HEATER CONTROL KNOB (for Manual Air Conditioning System)
Remove the heater control knob.
55900
11.REMOVE AIR CONDITIONING CONTROL ASSEMBLY (WINDOW DEFOGGER SWITCH) (for Manual Air Conditioning System)
Detach the claw and remove the air conditioning control assembly.