Home › General › SPECIFICATIONS › LIGHTING (EXT) › 2015.06–2015.11
RM33J0E _V1 General _038516 SPECIFICATIONS _0178241 LIGHTING (EXT) F

SPECIFICATIONS  LIGHTING (EXT)  SERVICE DATA  


HEADLIGHT DIMMER SWITCH (for LHD)
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected G3-18 (T) - G3-15 (EL) Light control switch off position 10 kΩ or higher
G3-19 (H) - G3-15 (EL)
G3-20 (A) - G3-15 (EL)
G3-20 (A) - G3-15 (EL) Light control switch AUTO position Below 1 Ω
G3-18 (T) - G3-15 (EL) Light control switch tail position Below 1 Ω
G3-19 (H) - G3-15 (EL) Light control switch head position Below 1 Ω
G3-18 (T) - G3-15 (EL)
G3-14 (HU) - G3-15 (EL) Headlight dimmer switch flash position Below 1 Ω
G3-17 (HF) - G3-15 (EL)
G3-14 (HU) - G3-15 (EL) Headlight dimmer switch high position Below 1 Ω
G3-12 (TR) - G3-15 (EL) Turn signal switch neutral position 10 kΩ or higher
G3-11 (TL) - G3-15 (EL)
G3-12 (TR) - G3-15 (EL) Turn signal switch right turn position
(self cancel condition)
Below 1 Ω
G3-12 (TR) - G3-15 (EL) Turn signal switch right turn position
(cancel ratchet operation condition)
Below 1 Ω
G3-12 (TR) - G3-13 (CR)
G3-13 (CR) - G3-15 (EL)
G3-11 (TL) - G3-15 (EL) Turn signal switch left turn position
(self cancel condition)
Below 1 Ω
G3-11 (TL) - G3-15 (EL) Turn signal switch in left turn position
(cancel ratchet operation condition)
Below 1 Ω
G3-11 (TL) - G3-13 (CR)
G3-13 (CR) - G3-15 (EL)
G3-9 (BFG) - G3-8 (LFG) Front fog light switch off 10 kΩ or higher
G3-9 (BFG) - G3-8 (LFG) Front fog light switch on Below 1 Ω

HINT:
·

The self cancel condition indicates when the turn signal switch returns to the neutral position when releasing your hand from the switch (switch is operated within 7°).

·

The cancel ratchet operation condition indicates the condition when the turn signal switch does not return to the neutral position even when releasing your hand (switch operation is 12°).



HEADLIGHT DIMMER SWITCH (for RHD)
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected G3-11 (A) - G3-16 (EL) Light control switch AUTO position Below 1 Ω
G3-13 (T) - G3-16 (EL) Light control switch tail position Below 1 Ω
G3-12 (H) - G3-16 (EL) Light control switch head position Below 1 Ω
G3-13 (T) - G3-16 (EL)
G3-14 (HF) - G3-16 (EL) Headlight dimmer switch flash position Below 1 Ω
G3-17 (HU) - G3-16 (EL)
G3-17 (HU) - G3-16 (EL) Headlight dimmer switch high position Below 1 Ω
G3-20 (TR) - G3-16 (EL) Turn signal switch neutral position 10 kΩ or higher
G3-19 (TL) - G3-16 (EL)
G3-20 (TR) - G3-16 (EL) Turn signal switch right turn position
(self cancel condition)
Below 1 Ω
G3-20 (TR) - G3-16 (EL) Turn signal switch right turn position
(cancel ratchet operation condition)
Below 1 Ω
G3-20 (TR) - G3-18 (CR)
G3-18 (CR) - G3-16 (EL)
G3-19 (TL) - G3-16 (EL) Turn signal switch left turn position
(self cancel condition)
Below 1 Ω
G3-19 (TL) - G3-16 (EL) Turn signal switch in left turn position
(cancel ratchet operation condition)
Below 1 Ω
G3-19 (TL) - G3-18 (CR)
G3-18 (CR) - G3-16 (EL)
G3-2 (BFG) - G3-3 (LFG) Front fog light switch off 10 kΩ or higher
G3-2 (BFG) - G3-3 (LFG) Front fog light switch on Below 1 Ω

HINT:
·

The self cancel condition indicates when the turn signal switch returns to the neutral position when releasing your hand from the switch (switch is operated within 7°).

·

The cancel ratchet operation condition indicates the condition when the turn signal switch does not return to the neutral position even when releasing your hand (switch operation is 12°).



HAZARD WARNING SWITCH
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected H3-3 (TB) - H3-1 (E) Hazard warning signal switch off 10 kΩ or higher
Hazard warning signal switch on Below 1 Ω

STOP LIGHT SWITCH
Connector Condition Tester Connection Switch Condition Specified Condition
Component without harness connected A27-1 - A27-2 Shaft not pushed 10 kΩ or higher
Shaft pushed Below 1 Ω
A27-3 - A27-4 Shaft not pushed Below 1 Ω
Shaft pushed 10 kΩ or higher

AUTOMATIC LIGHT CONTROL SENSOR
Connector Condition Tester Connection Condition Specified Condition
Component with harness connected H5-4 (CLTS) - H5-2 (CLTE) Ignition switch on (IG), light control switch in AUTO position Correct waveform is as shown

E276298N01
2.844,1.646 3.219,1.813 0.375,0.167 10 false GND

HINT:

The communication waveform changes according to the surrounding brightness.


RELAY (DIMMER Relay)
Connector Condition Tester Connection Condition Specified Condition
- 3 - 4 Battery voltage not applied to terminals 1 and 2 Below 1 Ω
Battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω

RELAY (H-LP Relay)
Connector Condition Tester Connection Condition Specified Condition
- 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω

RELAY (DRL Relay)
Connector Condition Tester Connection Condition Specified Condition
- 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery battery voltage applied to terminals 1 and 2 Below 1 Ω

RELAY (FOG FR Relay)
Connector Condition Tester Connection Condition Specified Condition
- 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery battery voltage applied to terminals 1 and 2 Below 1 Ω

RELAY (TAIL Relay)
Connector Condition Tester Connection Condition Specified Condition
- 3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery battery voltage applied to terminals 1 and 2 Below 1 Ω

RELAY (STOP/CDS FAN Relay)
Connector Condition Tester Connection Condition Specified Condition
- 3 - 4 Battery voltage not applied to terminals 1 and 2 Below 1 Ω
Battery battery voltage applied to terminals 1 and 2 10 kΩ or higher
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery battery voltage applied to terminals 1 and 2 Below 1 Ω