Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2015.11
RM33J0E _59 Vehicle Exterior _038498 LIGHTING (EXT) _0219141 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM U

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  TERMINALS OF ECU  


CHECK HEADLIGHT LEVELING ECU


E101528E41
3.354,0.115 3.792,0.365 0.438,0.25 3.438,0.156 3.854,0.333 0.417,0.177 10 false G80

a.

Disconnect the G80 headlight leveling ECU connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G80-1 (IG) - Body ground G- Body ground Ignition power supply Engine switch off Below 1 V
Engine switch on (IG) 11 to 14 V
G80-9 (E1) - Body ground W-B - Body ground Ground Always Below 1 Ω

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the G80 headlight leveling ECU connector.


d.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G80-10 (RH+) - G80-9 (E1) L - W-B Leveling motor RH power supply Engine switch off Below 1 V
Engine switch on (IG) 11 to 14 V
G80-11 (LH+) - G80-9 (E1) P - W-B Leveling motor LH power supply Engine switch off Below 1 V
Engine switch on (IG) 11 to 14 V
G80-12 (SBR) - G80-21 (SGR) B - LG Rear height control sensor power supply Engine switch off Below 1 V
Engine switch on (IG) 4.75 to 5.25 V
G80-17 (RHT) - G80-9 (E1) R - W-B Leveling motor RH operation signal input With low beam headlights on, vehicle height not changed Below 1 V
With low beam headlights on, vehicle height changed and maintained for more than 3 seconds 1.0 to 14.4 V
G80-18 (LHT) - G80-9 (E1) G - W-B Leveling motor LH operation signal input With low beam headlights on, vehicle height not changed Below 1 V
With low beam headlights on, vehicle height changed and maintained for more than 3 seconds 1.0 to 14.4 V
G80-19 (SHRL) - G80-21 (SGR) Y - LG Rear height control sensor signal input Engine switch on (IG)
(no passengers, no luggage, vehicle not moving)
Approximately 2.5 V (Vehicle is level)
(The value decreases as the front of the vehicle is raised.)
G80-21 (SGR) - G80-9 (E1) LG - W-B Rear height control sensor ground Always Below 1 Ω
G80-23 (RH-) - G80-9 (E1) L - W-B Leveling motor RH ground Always Below 1 Ω
G80-24 (LH-) - G80-9 (E1) Y - W-B Leveling motor LH ground Always Below 1 Ω