Home › Engine / Hybrid System › 2TR-FE STARTING › STARTER(for BOSCH Made) › from 2015.11
RM33J0E _51 Engine / Hybrid System _038461 2TR-FE STARTING _0225025 STARTER(for BOSCH Made) A

2TR-FE STARTING  STARTER(for BOSCH Made)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Temporarily install the starter assembly with the bolt.


b.

Temporarily install the clutch flexible hose bracket with the bolt.


c.

Tighten the 2 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


d.

Connect the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


e.

Connect the starter connector.


f.

Install the starter terminal cap.


Hide 2.CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY

Hide 53882K 3.INSTALL FRONT FENDER SEAL LH

a.

Install the front fender seal LH with new 6 clips.


Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION