Home › Drivetrain › RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE › MANUAL TRANSMISSION SYSTEM › from 2015.11
RM33J0E _52 Drivetrain _038468 RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE _0197906 MANUAL TRANSMISSION SYSTEM D

RC60 / RC61 MANUAL TRANSMISSION / TRANSAXLE  MANUAL TRANSMISSION SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using GTS)


a.

DTCs which are stored in the ECM can be output to the GTS.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 234

v.

Confirm the DTCs and freeze frame data, and then write them down.





CLEAR DTC (Using GTS)


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


e.

Clear the DTCs.

Powertrain > Engine > Clear DTCs
50002 234


CLEAR DTC (without Using GTS)


a.

Perform either of the following operations.

NOTICE:

After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


i.

Disconnect the cable from the negative (-) battery terminal for more than 1 minute.


ii.

Remove the EFI-B fuse from the engine room relay block and junction block assembly located inside the engine compartment for more than 1 minute.