Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type) › from 2015.11
RM33J0E _56 Audio / Visual / Telematics _038486 PARK ASSIST / MONITORING _0227355 REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type) U

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type)  TERMINALS OF ECU  


CHECK NAVIGATION RECEIVER ASSEMBLY


E322443N05
1.323,0.417 1.802,0.667 0.479,0.25 3.938,0.427 4.417,0.677 0.479,0.25 1.031,2.021 1.51,2.271 0.479,0.25 1.385,0.458 2,0.656 0.615,0.198 10 false G117 4,0.479 4.615,0.677 0.615,0.198 10 false G116 1.094,2.073 1.708,2.271 0.615,0.198 10 false G118

a.

Disconnect the G116 and G118 navigation receiver assembly connectors.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G116-1 (IG) - Body ground G - Body ground Power source of IG Ignition switch off Below 1 V
Ignition switch ON 11 to 14 V
G118-3 (ACC1) - Body ground GR - Body ground Power source of ACC Ignition switch off Below 1 V
Ignition switch ACC 11 to 14 V
G118-4 (+B1) - Body ground SB - Body ground Battery Always 11 to 14 V
G118-7 (GND1) - Body ground BR - Body ground Ground Always Below 1 Ω


c.

Reconnect the G116 and G118 navigation receiver assembly connectors.


d.

Measure the voltage and check for waveform according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
G116-2 (REV) - Body ground R - Body ground Reverse signal Ignition switch ON, shift lever in R 7.5 to 14 V
Ignition switch ON, shift lever not in R Below 1 V
G117-12 (V+) - G117-24 (V-) R - W Display signal Ignition switch ON, shift lever in R Pulse generation (See waveform 1)
Ignition switch ON, shift lever in R, screen blacked out by covering camera lens Pulse generation (See waveform 2)
G117-11 (CA+) - G117-23 (CGND) B - Shielded Power source Ignition switch ACC 5.5 to 7.05 V
G117-23 (CGND) - Body ground Shielded - Body ground Shielding Always Below 1 V


e.
E159949N05
0.196,1.018 0.531,1.162 0.335,0.144 10 GND

Using an oscilloscope, check waveform 1.

Measurement Condition
Item Content
Terminal No. (Symbol) G117-12 (V+) - G117-24 (V-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R


f.
E164781N04
0.275,1.002 0.612,1.146 0.337,0.145 10 GND

Using an oscilloscope, check waveform 2.

Measurement Condition
Item Content
Terminal No. (Symbol) G117-12 (V+) - G117-24 (V-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R, screen blacked out by covering camera lens