Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
86101J
1.INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
w/ Television Antenna
Attach the clamps to install the No. 2 antenna cord sub-assembly.
Connect the connectors.
Attach the guide and install the bolt.
w/o Television Antenna
Attach the clamps to install the No. 2 antenna cord sub-assembly.
Connect the connectors.
63310
2.INSTALL ROOF HEADLINING ASSEMBLY
for Single Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Single Cab)>INSTALLATION
for Smart Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Smart Cab)>INSTALLATION
for Double Cab:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING(for Double Cab)>INSTALLATION
86101
3.INSTALL ANTENNA CORD SUB-ASSEMBLY (for LHD)
w/ Navigation System:
Install the antenna cord sub-assembly with the bolt.
Attach the clamps shown in the illustration.
Connect the connector.
w/o Navigation System:
Install the antenna cord sub-assembly with the bolt.
Attach the clamps shown in the illustration.
Connect the connector.
86101
4.INSTALL ANTENNA CORD SUB-ASSEMBLY (for RHD)
w/ Navigation System:
Install the antenna cord sub-assembly with the bolt.
Attach the clamps shown in the illustration.
Connect the connector.
w/o Navigation System:
Install the antenna cord sub-assembly with the bolt.
Attach the clamps shown in the illustration.
Connect the connector.
55302A
5.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
7.CHECK SRS WARNING LIGHT