Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2015.11–2016.07
RM33J0E _58 Vehicle Interior _038499 METER / GAUGE / DISPLAY _0189806 METER / GAUGE SYSTEM D

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  OPERATION CHECK  


CHECK INDICATOR/WARNING LIGHT


a.

Check the following indicators and warning lights.

Indicator/Warning Light Switch Condition Specified Condition
Brake override system warning light Ignition switch off → ON Comes on for 3 seconds
Brake warning light
Slip indicator light (w/ VSC)
VSC OFF indicator light (w/ VSC)
TRC OFF indicator light (w/ VSC)
ABS warning light
Fuel system warning light (for Diesel Engine)
Eco driver indicator light (w/ Eco Drive Indicator Light)
T-BELT indicator light (for 1KD-FTV, 2KD-FTV)
DPF warning light (w/ DPF)
Downhill assist control system indicator light (w/ Downhill Assist Control)
iMT indicator light (for Intelligent Manual Transmission)
SRS warning light Ignition switch off → ON Comes on for 6 seconds
Low engine oil pressure warning light Ignition switch off → ON
·

Illuminates when ignition switch turned ON

·

Turns off when engine started


A/T OIL TEMP warning light (for 4WD, Automatic Transmission)
MIL (Malfunction indicator lamp)
Low engine oil level warning light (for 1GD-FTV, 2GD-FTV)



CHECK SPEEDOMETER


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

Chassis > ABS/VSC/TRC > Data List
Tester Display Measurement Item Normal Condition Reference Value Diagnostic Note
Vehicle Speed Vehicle speed Min.: 0 km/h (0 mph), Max.: 326.4 km/h (202.8 mph) Almost same as actual vehicle speed -
Chassis > ABS/VSC/TRC > Data List
Tester Display
Vehicle Speed
50003 105 42
for km/h
Standard Indication (km/h) Acceptable Range (km/h)
20 21 to 25
40 41.7 to 46.2
60 62.7 to 67.2
80 83.4 to 88.4
100 104.3 to 109.3
120 125.1 to 130.6
140 145.8 to 151.8
160 166.2 to 173.2
180 186.9 to 194.5

If the result is not as specified, the speedometer may have a malfunction.

NOTICE:

Do not use worn, underinflated or overinflated tires as the speedometer reading will be inaccurate.



e.

Check the deflection width of the speedometer indicator.

Reference:

Within 0.3°




CHECK TACHOMETER


a.

Connect a tune-up tachometer and start the engine.


b.

Compare the test results with the tachometer indicator.

DC 13.5 V at 25°C (77°F)
Standard Indication (rpm) Acceptable Range
Data in ( ) is for Reference (rpm)

*: for 2TR-FE

700 630 to 770
1000 (900 to 1100)
2000 (1850 to 2150)
3000 2800 to 3200
4000 (3800 to 4200)
5000 4800 to 5200
6000* (5750 to 6250)

If the result is not as specified, the tachometer may have a malfunction.



CHECK METER/GAUGE


a.

Connect the GTS to the DLC3.


b.

Perform the Active Test.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

OK:

Each meter/gauge needle indication is normal.




CHECK WARNING/INDICATOR LIGHT


a.

Connect the GTS to the DLC3.


b.

Perform the Active Test.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

OK:

Each warning/indicator light can be turned on and off using the GTS.




CHECK MULTI-INFORMATION DISPLAY (except Segment Display Type)


a.

Connect the GTS to the DLC3.


b.

Perform the Active Test.

Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST

OK:

All dots in the multi-information display can be turned on and off using the GTS.