Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT PROPELLER SHAFT ASSEMBLY(for TASA Made) › from 2015.11
RM33J0E _52 Drivetrain _038471 DRIVE SHAFT / PROPELLER SHAFT _0233202 FRONT PROPELLER SHAFT ASSEMBLY(for TASA Made) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT PROPELLER SHAFT ASSEMBLY(for TASA Made)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 37140 1.INSPECT FRONT PROPELLER SHAFT ASSEMBLY

F052087

a.

Using a dial indicator, check the front propeller shaft assembly runout.

Maximum runout:

0.8 mm (0.0314 in.)


If the front propeller shaft assembly runout is more than the maximum, replace the front propeller shaft assembly.


Hide 2.INSPECT UNIVERSAL JOINT SPIDER ASSEMBLY

a.

Check the spider bearings for wear or damage.

If necessary, replace the spider bearings.


b.
C113731

Check the spider bearing axial play by turning the yoke while holding the front propeller shaft assembly tightly.

Maximum bearing axial play:

0.05 mm (0.00196 in.)


If the axial play is more than the maximum, replace the spider bearings.