| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Retainer plate x Generator drive end frame *1 | 2.3 | 23 | 20 | ||||
| Generator coil assembly x Generator drive end frame *1 | 5.6 | 57 | 50 | ||||
| Generator brush holder assembly x Generator coil assembly *1 | 1.8 | 18 | 16 | ||||
| Generator rear end cover x Generator coil assembly *1 | 4.6 | 47 | 41 | ||||
| Generator pulley with clutch x Generator rotor assembly *1 | without SST | 80 | 816 | 59 | |||
| with SST | 64 | 653 | 47 | ||||
| Generator pulley with clutch x Generator rotor assembly *2 | 80 | 816 | 59 | ||||
| Generator assembly x Cylinder block | 43 | 438 | 32 | ||||
| Generator wire x Terminal B | 9.8 | 100 | 87 | ||||
| Generator assembly x Generator bracket | 13 | 133 | 10 | ||||
| Negative (-) battery terminal x No. 2 engine wire | 7.6 | 77 | 67 | ||||
| Positive (+) cable x Positive (+) battery terminal | 5.4 | 55 | 48 | ||||
| Negative (-) cable x Negative (-) battery terminal | 5.4 | 55 | 48 | ||||
*1: for 80 A Type:
*2: for 90 A Type: