Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR › from 2015.11
RM33J0E _59 Vehicle Exterior _038498 LIGHTING (EXT) _0234537 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear height control sensor sub-assembly installation/removal are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components Headlight leveling ECU assembly initialization Automatic headlight beam level control system (Click here)

PROCEDURE

Hide 48923A 1.REMOVE HEIGHT CONTROL LINK COVER

a.
E316972

Remove the 2 bolts and height control link cover.


Hide 89408C 2.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
E316973

Disconnect the connector.


b.
E316974

Remove the 3 bolts and rear height control sensor sub-assembly LH.


c.
E316975

Detach the wire harness clamp.

NOTICE:

If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.