Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH › from 2015.11
RM33J0E _59 Vehicle Exterior _038498 LIGHTING (EXT) _0189325 HAZARD WARNING SWITCH A

LIGHTING (EXT)  HAZARD WARNING SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

for Type A:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type A)>PRECAUTION

for Type B:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY (w/ Navigation System)

Hide 55085 5.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)

Hide 55084E 6.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Navigation System)

Hide 55844 7.REMOVE NO. 2 HEATER TO REGISTER DUCT (w/ Navigation System)

Hide 83910G 8.REMOVE CLOCK ASSEMBLY (Hazard Warning Switch)

a.
E320309

Disconnect the connector.


b.
E320310

Remove the screw and clock assembly (hazard warning switch).