| Connector Condition | Tester Connection | Switch Condition | Specified Condition |
|---|---|---|---|
| Component without harness connected | G3-18 (T) - G3-15 (EL) | Light control switch off position | 10 kΩ or higher |
| G3-19 (H) - G3-15 (EL) | |||
| G3-20 (A) - G3-15 (EL) | |||
| G3-20 (A) - G3-15 (EL) | Light control switch AUTO position | Below 1 Ω | |
| G3-18 (T) - G3-15 (EL) | Light control switch tail position | Below 1 Ω | |
| G3-19 (H) - G3-15 (EL) | Light control switch head position | Below 1 Ω | |
| G3-18 (T) - G3-15 (EL) | |||
| G3-14 (HU) - G3-15 (EL) | Headlight dimmer switch flash position | Below 1 Ω | |
| G3-17 (HF) - G3-15 (EL) | |||
| G3-14 (HU) - G3-15 (EL) | Headlight dimmer switch high position | Below 1 Ω | |
| G3-12 (TR) - G3-15 (EL) | Turn signal switch neutral position | 10 kΩ or higher | |
| G3-11 (TL) - G3-15 (EL) | |||
| G3-12 (TR) - G3-15 (EL) | Turn signal switch right turn position
(self cancel condition) |
Below 1 Ω | |
| G3-12 (TR) - G3-15 (EL) | Turn signal switch right turn position
(cancel ratchet operation condition) |
Below 1 Ω | |
| G3-12 (TR) - G3-13 (CR) | |||
| G3-13 (CR) - G3-15 (EL) | |||
| G3-11 (TL) - G3-15 (EL) | Turn signal switch left turn position
(self cancel condition) |
Below 1 Ω | |
| G3-11 (TL) - G3-15 (EL) | Turn signal switch in left turn position
(cancel ratchet operation condition) |
Below 1 Ω | |
| G3-11 (TL) - G3-13 (CR) | |||
| G3-13 (CR) - G3-15 (EL) | |||
| G3-9 (BFG) - G3-8 (LFG) | Front fog light switch off | 10 kΩ or higher | |
| G3-9 (BFG) - G3-8 (LFG) | Front fog light switch on | Below 1 Ω | |
| G3-4 (B) - G3-8 (LFG) | Rear fog light switch off | 10 kΩ or higher | |
| G3-4 (B) - G3-10 (BFG) | |||
| G3-4 (B) - G3-8 (LFG) | Rear fog light switch on | Below 1 Ω | |
| G3-4 (B) - G3-10 (BFG) |
The self cancel condition indicates when the turn signal switch returns to the neutral position when releasing your hand from the switch (switch is operated within 7°).
The cancel ratchet operation condition indicates the condition when the turn signal switch does not return to the neutral position even when releasing your hand (switch operation is 12°).
| Connector Condition | Tester Connection | Switch Condition | Specified Condition |
|---|---|---|---|
| Component without harness connected | G3-11 (A) - G3-16 (EL) | Light control switch AUTO position | Below 1 Ω |
| G3-13 (T) - G3-16 (EL) | Light control switch tail position | Below 1 Ω | |
| G3-12 (H) - G3-16 (EL) | Light control switch head position | Below 1 Ω | |
| G3-13 (T) - G3-16 (EL) | |||
| G3-14 (HF) - G3-16 (EL) | Headlight dimmer switch flash position | Below 1 Ω | |
| G3-17 (HU) - G3-16 (EL) | |||
| G3-17 (HU) - G3-16 (EL) | Headlight dimmer switch high position | Below 1 Ω | |
| G3-20 (TR) - G3-16 (EL) | Turn signal switch neutral position | 10 kΩ or higher | |
| G3-19 (TL) - G3-16 (EL) | |||
| G3-20 (TR) - G3-16 (EL) | Turn signal switch right turn position
(self cancel condition) |
Below 1 Ω | |
| G3-20 (TR) - G3-16 (EL) | Turn signal switch right turn position
(cancel ratchet operation condition) |
Below 1 Ω | |
| G3-20 (TR) - G3-18 (CR) | |||
| G3-18 (CR) - G3-16 (EL) | |||
| G3-19 (TL) - G3-16 (EL) | Turn signal switch left turn position
(self cancel condition) |
Below 1 Ω | |
| G3-19 (TL) - G3-16 (EL) | Turn signal switch in left turn position
(cancel ratchet operation condition) |
Below 1 Ω | |
| G3-19 (TL) - G3-18 (CR) | |||
| G3-18 (CR) - G3-16 (EL) | |||
| G3-2 (BFG) - G3-3 (LFG) | Front fog light switch off | 10 kΩ or higher | |
| G3-2 (BFG) - G3-3 (LFG) | Front fog light switch on | Below 1 Ω |
The self cancel condition indicates when the turn signal switch returns to the neutral position when releasing your hand from the switch (switch is operated within 7°).
The cancel ratchet operation condition indicates the condition when the turn signal switch does not return to the neutral position even when releasing your hand (switch operation is 12°).
| Connector Condition | Tester Connection | Switch Condition | Specified Condition |
|---|---|---|---|
| Component without harness connected | H3-3 (TB) - H3-1 (E) | Hazard warning signal switch off | 10 kΩ or higher |
| Hazard warning signal switch on | Below 1 Ω |
| Connector Condition | Tester Connection | Switch Condition | Specified Condition |
|---|---|---|---|
| Component without harness connected | A27-1 - A27-2 | Shaft not pushed | 10 kΩ or higher |
| Shaft pushed | Below 1 Ω | ||
| A27-3 - A27-4 | Shaft not pushed | Below 1 Ω | |
| Shaft pushed | 10 kΩ or higher |
| Connector Condition | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| Component with harness connected | H5-4 (CLTS) - H5-2 (CLTE) | Ignition switch on (IG), light control switch in AUTO position | Correct waveform is as shown |
The communication waveform changes according to the surrounding brightness.
| Connector Condition | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| - | 3 - 4 | Battery voltage not applied to terminals 1 and 2 | Below 1 Ω |
| Battery voltage applied to terminals 1 and 2 | 10 kΩ or higher | ||
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher | |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
| Connector Condition | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| - | 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage applied to terminals 1 and 2 | Below 1 Ω |
| Connector Condition | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| - | 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery battery voltage applied to terminals 1 and 2 | Below 1 Ω |
| Connector Condition | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| - | 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery battery voltage applied to terminals 1 and 2 | Below 1 Ω |
| Connector Condition | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| - | 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery battery voltage applied to terminals 1 and 2 | Below 1 Ω |
| Connector Condition | Tester Connection | Condition | Specified Condition |
|---|---|---|---|
| - | 3 - 4 | Battery voltage not applied to terminals 1 and 2 | Below 1 Ω |
| Battery battery voltage applied to terminals 1 and 2 | 10 kΩ or higher | ||
| 3 - 5 | Battery voltage not applied to terminals 1 and 2 | 10 kΩ or higher | |
| Battery battery voltage applied to terminals 1 and 2 | Below 1 Ω |