88688N
1.REMOVE COOLER BRACKET
| *A | for Type A |
| *B | for Type B |
Detach the clamp.
Remove the screw and cooler bracket.
88410
2.REMOVE MAGNET CLUTCH ASSEMBLY
| *A | for Type A |
| *B | for Type B |
| *a | SST |
Clamp the compressor assembly with magnet clutch in a vise between aluminum plates.
for Type A:
Using SST, hold the magnet clutch hub.
for Type B:
Using SST, hold the magnet clutch hub.
Remove the bolt, magnet clutch hub and magnet clutch washer(s).
There is no set number of magnet clutch washers that are used for adjusting clutch clearance.
Using a snap ring expander, remove the snap ring and magnet clutch rotor.
Do not damage the seal cover of the bearing when removing the snap ring.
Using a snap ring expander, remove the snap ring and magnet clutch stator.