Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › from 2015.11
RM33J0E _59 Vehicle Exterior _038514 EXTERIOR PANELS / TRIM _0188890 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

As the rear bumper assembly is extremely heavy, the engine lifter may suddenly drop if the instructions listed in the repair manual are not followed. Therefore, always follow the instructions listed in the repair manual when performing this procedure.


PROCEDURE

Hide 1.INSTALL REAR BUMPER ASSEMBLY

a.

Temporarily install the 2 temporary bolts to the vehicle body.

B399486C01
1.219,2.521 1.229,2.542 false
V100135

Bolt
V100136

Temporary Bolt



b.

Using an engine lifter or equivalent, install the rear bumper assembly with the 2 bolts, and then tighten the 2 temporary bolts.

Torque:
45 N*m (459 kgf*cm, 33 ft.*lbf)

NOTICE:
·

Using plate lift attachments or equivalent, set the rear bumper assembly on a flat surface.

·

Be sure to perform the operation with 2 persons or more.

·

Be careful not to damage the rear bumper assembly.



HINT:

Install the rear bumper assembly so that it is level to the ground.



Hide 75102 2.INSTALL REAR LICENSE PLATE BRACKET SUB-ASSEMBLY (for Deck-less)

a.
B442432

Install the rear license plate bracket sub-assembly with the 2 bolts..

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


Hide 81270 3.INSTALL LICENSE PLATE LIGHT ASSEMBLY (for Deck-less)