Home › General › SPECIFICATIONS › 1GD-FTV FUEL › from 2015.11
RM33J0E _V1 General _038516 SPECIFICATIONS _0178138 1GD-FTV FUEL F

SPECIFICATIONS  1GD-FTV FUEL  SERVICE DATA  


FUEL INJECTOR
Item Tester Connection Condition Specified Condition
Fuel Pressure Sensor Side
(for i-ART)
1 (GND) - 4 (Vout) 25°C (77°F) 16.4 kΩ or less
2 (VC) - 4 (Vout) 3.5 kΩ or less
Injector Side (for i-ART) No. 1 Injector Assembly
3 (#1) - 6 (#10)
20°C (68°F) 0.52 to 0.66 Ω
No. 2 Injector Assembly
3 (#2) - 6 (#20)
No. 3 Injector Assembly
3 (#3) - 6 (#30)
No. 4 Injector Assembly
3 (#4) - 6 (#40)
Injector Side (except i-ART) 1 - 2

FUEL SUPPLY PUMP
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 0.42 to 0.52 Ω

COMMON RAIL
Item Tester Connection Condition Specified Condition
Fuel Pressure Sensor
(except i-ART)
5 (PR) - 4 (E2) 25°C (77°F) 16.4 kΩ or less
2 (PR2) - 3 (E2S) 16.4 kΩ or less
6 (VC) - 5 (PR) 3 kΩ or less
1 (VCS) - 2 (PR2) 3 kΩ or less
Pressure Discharge Valve 1 - 2 20°C (68°F) 0.42 to 0.52 Ω

FUEL FILTER
Item Tester Connection Condition Specified Condition
Level Warning Switch 3 - 4 Float at upper end position Below 1 Ω
Float at lower end position 10 kΩ or higher
Clogging Switch 1 - 2 20°C (68°F) Below 1 Ω

FUEL SENDER GAUGE ASSEMBLY
Tester Connection Condition Specified Condition
2 (FE) - 3 (FR) Float position is F (upper) 4.25 to 4.61 V*
Float position is E (lower) 0.34 to 0.70 V*

*: The output voltage changes depending on the voltage applied to the terminals.