Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › ECM › from 2015.11
RM33J0E _51 Engine / Hybrid System _038420 1GD-FTV ENGINE CONTROL _0195868 ECM A

1GD-FTV ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the ECM removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM
·

Learning values save

·

Learning values write

·

Vehicle Identification Number (VIN) registration


·

Engine starting

·

DTC P0630 is output


(Click here)
w/DPF:(Click here)
for i-ART:(Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE

Hide 55607 1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Cover)

Hide 55550 2.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 89661 3.REMOVE ECM

a.
A349887

Detach the 2 clamps.


b.

Disconnect the 2 4 wheel drive control ECU connectors and 6 ECM connectors.


c.

Remove the bolt, 2 nuts and ECM with the 4 wheel drive control ECU.


Hide 89533 4.REMOVE 4 WHEEL DRIVE CONTROL ECU (for 4WD)

Hide 89667A 5.REMOVE NO. 1 ECM BRACKET

a.
A349888

Remove the 2 screws and No. 1 ECM bracket.


Hide 89668A 6.REMOVE NO. 2 ECM BRACKET

a.
A349889

Remove the 2 screws and No. 2 ECM bracket.