Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › ECM › from 2016.07
RM33J0E _51 Engine / Hybrid System _053773 2TR-FBE ENGINE CONTROL _0264891 ECM A

2TR-FBE ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the ECM removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of ECM Vehicle Identification Number (VIN) registration DTC P0630 is output (Click here)
Code registration (Immobiliser system) Engine start function See the Service Bulletin for the registration method.

PROCEDURE

Hide 55607 1.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Cover)

Hide 55550 2.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 89661 3.REMOVE ECM

a.

for 4WD:

Disconnect the 2 connectors from the 4 wheel drive control ECU.


b.

Disconnect the 4 connectors from the ECM.


c.

Detach the 2 clamps.


d.
A349265

Remove the bolt, 2 nuts and ECM.


Hide 89533 4.REMOVE 4 WHEEL DRIVE CONTROL ECU (for 4WD)

Hide 89667A 5.REMOVE NO. 1 ECM BRACKET

a.
A344404

Remove the 2 screws and No. 1 ECM bracket.


Hide 89668A 6.REMOVE NO. 2 ECM BRACKET

a.
A344405

Remove the 2 screws and No. 2 ECM bracket.