Do not your hands into the water that has been heated for the inspection.
Touching the heated water could result in burns.
89422
1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | 20°C (68°F) | 2.32 to 2.59 kΩ |
| 80°C (176°F) | 0.310 to 0.326 kΩ |
| *a | Component without harness connected
(Engine Coolant Temperature Sensor) |
*b | Resistance |
| *c | Temperature | *d | Acceptable Range |
Do not your hands into the water that has been heated for the inspection.
Touching the heated water could result in burns.
If checking the engine coolant temperature sensor in water, be careful not to allow water to contact the terminals. After checking, clean off any water on the engine coolant temperature sensor.
If the result is not as specified, replace the engine coolant temperature sensor.