Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2016.07
RM33J0E _51 Engine / Hybrid System _053773 2TR-FBE ENGINE CONTROL _0264898 ENGINE COOLANT TEMPERATURE SENSOR A

2TR-FBE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of engine coolant temperature sensor Inspection After Repair Poor idle, engine start, etc. (Click here)

PROCEDURE

Hide 89422 2.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A345928

Disconnect the engine coolant temperature sensor connector.


b.

Remove the engine coolant temperature sensor.


c.

Remove the gasket from the engine coolant temperature sensor.