Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › MANIFOLD ABSOLUTE PRESSURE SENSOR › from 2016.07
RM33J0E _51 Engine / Hybrid System _053773 2TR-FBE ENGINE CONTROL _0264900 MANIFOLD ABSOLUTE PRESSURE SENSOR G

2TR-FBE ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89421N 1.CHECK AIR PRESSURE SENSOR

a.
A124891C02
2.635,1.635 2.521,1.635 2.521,1.635 2.094,1.229 true 0.792,1.635 0.948,1.635 0.948,1.635 1.344,1.24 true 0.552,1.563 0.792,1.74 0.24,0.177 10 E2 2.677,1.552 2.938,1.729 0.26,0.177 10 VC 0.063,0.073 0.24,0.271 0.177,0.198 10 *a
*a Front view of wire harness connector
(to Air Pressure Sensor)


Inspect the power source voltage.

i.

Disconnect the air pressure sensor connector.


ii.

Turn the ignition switch to ON.


iii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
3 (VC) - 1 (E2) Ignition switch to ON 4.75 to 5.25 V



iv.

Turn the ignition switch off.


v.

Connect the air pressure sensor connector.



b.

Check the pressure.

i.
A345932

Connect a pressure gauge to the air pressure sensor as shown in the illustration.


ii.

Connect the GTS to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the GTS on.


v.

Enter the following menus: Powertrain / Engine and ECT / Data List / Air Pump Pressure (absolute).

Powertrain > Engine and ECT > Data List
Tester Display
Air Pump Pressure (Absolute)
50003 234 181

vi.

Check that the pressure displayed on the GTS fluctuates when applying pressure to the air pressure sensor with the pressure gauge.

OK:

Pressure fluctuates in response to pressure applied with pressure gauge.


HINT:

The GTS displays the air pump pressure (Air Pump Pressure (absolute)) as absolute pressure.


If the result is not as specified, replace the air pressure sensor.