Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › POWER STEERING OIL PRESSURE SWITCH › from 2016.07
RM33J0E _51 Engine / Hybrid System _053773 2TR-FBE ENGINE CONTROL _0264903 POWER STEERING OIL PRESSURE SWITCH A

2TR-FBE ENGINE CONTROL  POWER STEERING OIL PRESSURE SWITCH  INSTALLATION  


PROCEDURE

Hide 89438D 1.INSTALL POWER STEERING OIL PRESSURE SWITCH

a.

Apply a light coat of engine oil to the O-ring of the power steering oil pressure switch.


b.

Using a 19 mm deep socket wrench, install the power steering oil pressure switch.

Torque:
20.6 N*m (210 kgf*cm, 15 ft.*lbf)

NOTICE:
·

Do not allow foreign matter to contact the oil seal face of the power steering oil pressure switch (the surface that contacts the pressure feed tube).

·

When reusing the power steering oil pressure switch, inspect the O-ring.

·

Make sure that the O-ring is not cracked or jammed when installing the power steering oil pressure switch.




c.

Connect the power steering oil pressure switch connector.


Hide 2.ADD POWER STEERING FLUID

Hide 3.BLEED AIR FROM POWER STEERING SYSTEM

Hide 4.INSPECT FOR POWER STEERING FLUID LEAK