Home › Engine / Hybrid System › 2TR-FBE FUEL › FUEL PUMP › from 2016.07
RM33J0E _51 Engine / Hybrid System _053775 2TR-FBE FUEL _0264910 FUEL PUMP G

2TR-FBE FUEL  FUEL PUMP  INSPECTION  


PROCEDURE

Hide 23220A 1.INSPECT FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY (FUEL PUMP)

a.
A302875C01
0.094,0.115 0.406,0.271 0.313,0.156 10 false *a
*a Component without harness connected
(Fuel Pump)


Check the fuel pump resistance.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 - 5 20°C (68°F) 0.2 to 3.0 Ω


If the result is not as specified, replace the fuel suction with pump and gauge tube assembly (fuel pump).



b.

Check fuel pump operation.

i.

Apply battery voltage to terminals 4 and 5. Check that the pump operates.

NOTICE:
·

These tests must be performed within 10 seconds to prevent the coil from burning out.

·

Keep the fuel pump as far away from the battery as possible.

·

Always turn the voltage on and off at the battery, not the fuel pump.



If the pump does not operate, replace the fuel suction with pump and gauge tube assembly (fuel pump).