Home › Engine / Hybrid System › 2TR-FBE STARTING › IGNITION SWITCH › from 2016.07
RM33J0E _51 Engine / Hybrid System _053780 2TR-FBE STARTING _0264954 IGNITION SWITCH G

2TR-FBE STARTING  IGNITION SWITCH  INSPECTION  


PROCEDURE

Hide 84450 1.INSPECT IGNITION SWITCH ASSEMBLY

a.
A296191C01
2.188,1.271 2.656,1.438 true 1.51,1.302 1.281,1.781 true 1.917,1.021 2.469,0.531 true 1.51,1.031 1.177,0.51 true 1.229,1.271 0.813,1.49 true 1.927,1.302 2.177,1.729 true 1.219,1.052 0.802,0.896 true 0.042,0.042 0.354,0.198 0.313,0.156 10 *a 2.74,1.375 3.177,1.573 0.438,0.198 10 AM1 1.083,1.823 1.521,2.021 0.438,0.198 10 ACC 2.583,0.427 3.021,0.625 0.438,0.198 10 ST2 0.865,0.344 1.302,0.542 0.438,0.198 10 IG2 0.5,1.385 0.938,1.583 0.438,0.198 10 IG1 2.104,1.802 2.542,2 0.438,0.198 10 ST1 0.448,0.823 0.885,1.021 0.438,0.198 10 AM2
*a Component without harness connected
(Ignition Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
- LOCK 10 kΩ or higher
7 (ACC) - 5 (AM1) ACC Below 1 Ω
8 (IG1) - 5 (AM1)
7 (ACC) - 5 (AM1)
4 (AM2) - 3 (IG2)
ON Below 1 Ω
8 (IG1) - 5 (AM1)
6 (ST1) - 5 (AM1)
4 (AM2) - 3 (IG2)
4 (AM2) - 2 (ST2)
START Below 1 Ω


If the result is not as specified, replace the ignition switch assembly.