The radio and display receiver assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function.
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls its respective system based on this pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
| *a | Component with harness connected
(Combination Meter Assembly) |
Check the output waveform.
Remove the combination meter assembly with the connector still connected.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL
Connect an oscilloscope to terminal G9-19 (+S) and body ground.
Turn the ignition switch to ON.
Turn a wheel slowly.
Check the signal waveform according to the condition(s) in the table below.
| Item | Condition |
|---|---|
| Measurement terminal | G9-19 (+S) - Body ground |
| Tool setting | 5 V/DIV, 20 ms./DIV |
| Vehicle condition | Wheel being rotated |
The waveform is similar to that shown in the illustration.
When the system is functioning normally, one wheel revolution generates 4 pulses. As the vehicle speed increases, the width indicated by (A) in the illustration narrows.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
*1: for 2TR-FE, 2TR-FBE
*2: for 1GD-FTV
*3: for 1KD-FTV
*4: w/ Smart Entry and Start System
*5: w/ Speed-sensitive Automatic Door Lock Function
*6: for 1KD-FTV, Automatic Transmission
Disconnect the G37 radio and display receiver assembly connector.
Disconnect the G9 combination meter assembly connector.
Disconnect the G45*1, G85*2 or G83*3 ECM connector.
Disconnect the G69 certification ECU (smart key ECU assembly) connector.*4
Disconnect the G27 body ECU connector.*5
Disconnect the G90 TCM connector.*6
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-17 (SPD) - G9-19 (+S) | Always | Below 1 Ω |
| G37-17 (SPD) or G9-19 (+S) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG