To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
12601B
1.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
89425
2.REMOVE EXHAUST GAS TEMPERATURE SENSOR (for i-ART)
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disconnect the 2 connectors from the 2 exhaust gas temperature sensors.
Remove the bolt and open the clamp of the pipe clamp.
Detach the 2 connectors from the pipe clamp.
Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.
Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.
89425
3.REMOVE EXHAUST GAS TEMPERATURE SENSOR (w/ DPF)
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Disconnect the 3 connectors from the 3 exhaust gas temperature sensors.
Remove the nut and disconnect the No. 3 exhaust gas temperature sensor from the No. 1 vacuum pipe.
Remove the bolt and open the clamp of the pipe clamp.
Detach the 3 connectors from the pipe clamp.
Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.
Using a 14 mm union nut wrench, remove the No. 2 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.
Using a 14 mm union nut wrench, remove the No. 3 exhaust gas temperature sensor from the exhaust manifold converter sub-assembly.