Home › Suspension › REAR SUSPENSION › REAR SHOCK ABSORBER
RM3270E _53 Suspension _041689 REAR SUSPENSION _0195321 REAR SHOCK ABSORBER A

REAR SUSPENSION  REAR SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 48540 1.INSTALL REAR SHOCK ABSORBER ASSEMBLY LH

a.
C324612C01
1.438,0.646 1.688,0.646 false 1.833,1.167 2,0.833 2,0.833 2.167,0.833 false 2.896,3.083 3.208,3.281 0.313,0.198 10 false *a 0.146,1.323 0.458,1.521 0.313,0.198 10 false *b 1.531,1.969 1.844,2.167 0.313,0.198 10 false *c 1.75,0.573 2.063,0.771 0.313,0.198 10 false *d 2.229,0.75 2.542,0.948 0.313,0.198 10 false *e
*a Turn
*b Hold
*c Torque Wrench Fulcrum Length
*d 12 x 14 mm Long Offset Wrench
*e 12 mm Socket Hexagon Wrench


Using a 12 mm socket hexagon wrench and 12 x 14 mm long offset wrench, install the 3 rear shock absorber cushion retainers, rear No. 1 shock absorber cushion, rear upper shock absorber bracket LH, rear No. 2 shock absorber cushion and a new lock nut to the rear shock absorber assembly LH.

Torque:
Specified tightening torque : 20 N*m (204 kgf*cm, 15 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a long offset wrench (fulcrum length of 206.25 mm (8.1201 in.)) + torque wrench (fulcrum length of 300 mm (11.8110 in.)): 11.9 N*m (121 kgf*cm, 9 ft.*lbf)




b.
C334033

Temporarily install the rear shock absorber assembly LH to the axle housing with the bolt.


c.
C334035C01
0.583,0.583 0.896,0.781 0.313,0.198 10 false *a
*a Vehicle Exterior


Install the rear shock absorber assembly LH to the frame with the 2 bolts.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

HINT:

Make sure that the cutout of the rear upper shock absorber bracket LH faces the vehicle exterior.



Hide 3.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several time to stabilize the suspension.


Hide 48540 4.TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

a.

Tighten the bolt.

Torque:
98 N*m (999 kgf*cm, 72 ft.*lbf)


Hide 5.PERFORM INITIALIZATION (w/ Automatic Headlight Beam Level Control System)

Hide 6.INSPECT AUTOMATIC LIGHT CONTROL SYSTEM (w/ Automatic Headlight Beam Level Control System)

Hide 7.INSPECT HEADLIGHT AIMING (w/ Automatic Headlight Beam Level Control System)