The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear shock absorber removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
48540
2.REMOVE REAR SHOCK ABSORBER ASSEMBLY LH
Support the axle housing.
Jack up and support the vehicle's frame on stands.
Lower the axle housing until the coil spring tension is free, and maintain this position.
Remove the 2 bolts.
Remove the bolt.
Disconnect the rear shock absorber assembly LH from the axle housing and frame.
| *a | Turn |
| *b | Hold |
Remove the lock nut, 3 rear shock absorber cushion retainers, rear No. 1 shock absorber cushion, rear upper shock absorber bracket LH and rear No. 2 shock absorber cushion.