The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear upper arm removal/installation are shown below.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
89408C
2.DISCONNECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ Automatic Headlight Beam Level Control System)
Remove the nut and disconnect the rear height control sensor sub-assembly LH from the upper control arm assembly.
48710
3.REMOVE UPPER CONTROL ARM ASSEMBLY
Remove the 2 bolts, 2 nuts and upper control arm assembly from the axle housing.
While fixing the nuts in place, loosen and remove the bolts.