The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear stabilizer bar removal/installation are shown below.
1.REMOVE REAR WHEEL
48840A
2.REMOVE REAR STABILIZER LINK ASSEMBLY LH
Remove the 2 nuts and rear stabilizer link assembly LH.
If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud in place.
48830D
3.REMOVE REAR STABILIZER LINK ASSEMBLY RH
Use the same procedure described for the LH side.
48823C
4.REMOVE REAR STABILIZER BRACKET COVER
Remove the 2 bolts, 2 nuts and 2 rear stabilizer bracket covers.
48818
5.REMOVE REAR STABILIZER BUSH
Remove the 2 rear stabilizer bushes.
48812
6.REMOVE REAR STABILIZER BAR
Remove the rear stabilizer bar.