84490A
1.INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY
| *a | Component without harness connected
(Back Sonar or Clearance Sonar Switch Assembly) |
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (ECU) - 6 (IG) | Back sonar or clearance sonar switch assembly off | 10 kΩ or higher |
| Back sonar or clearance sonar switch assembly on | Below 1 Ω |
Inspect the indicator operation.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (ECU)
Battery negative (-) → Terminal 7 (E) |
LED illuminates |
If the result is not as specified, replace the back sonar or clearance sonar switch assembly.
Inspect the illumination operation.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-) |
LED illuminates |
If the result is not as specified, replace the back sonar or clearance sonar switch assembly.