The No. 1 stereo jack adapter assembly sends the display signal from an external device to the radio and display receiver assembly via this circuit.
Disconnect the G100 radio and display receiver assembly connector.
Disconnect the aG1 radio wiring sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G100-13 (VV+) - aG1-8 | Always | Below 1 Ω |
| G100-14 (VV-) - aG1-9 | Always | Below 1 Ω |
| G100-12 (SG) - aG1-1 | Always | Below 1 Ω |
| G100-13 (VV+) or aG1-8 - Body ground | Always | 10 kΩ or higher |
| G100-14 (VV-) or aG1-9 - Body ground | Always | 10 kΩ or higher |
| G100-12 (SG) or aG1-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
| *b | Front view of wire harness connector
(to Vehicle Wire Harness) |
Disconnect the No. 1 stereo jack adapter assembly connector.
Disconnect the vehicle wire harness connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| a1-6 (VV+) - aG1-8 | Always | Below 1 Ω |
| a1-11 (VV-) - aG1-9 | Always | Below 1 Ω |
| a1-6 (VV+) or aG1-8 - Body ground | Always | 10 kΩ or higher |
| a1-11 (VV-) or aG1-9 - Body ground | Always | 10 kΩ or higher |
| aG1-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG