Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81210B
1.REMOVE FOG LIGHT BULB
| *a | 90° |
|
Turn in this Direction |
Turn the pin hold clip 90° and then pull the pin hold clip to remove it.
Remove the 3 screws and 4 clips and disconnect the front fender splash shield sub-assembly LH.
Disconnect the connector.
|
Counterclockwise |
Turn the fog light bulb counterclockwise until the bulb stops.
Remove the fog light bulb.
Do not touch the glass part of the fog light bulb.
81210B
2.INSTALL FOG LIGHT BULB
|
Clockwise |
Insert the fog light bulb into place.
Do not touch the glass part of the fog light bulb.
Turn the fog light bulb clockwise until the bulb stops to install it.
Return the front fender splash shield sub-assembly LH to its original position and install the 3 screws and 4 clips.
| *a | 90° |
|
Turn in this Direction |
Insert and turn the pin hold clip 90° to install it.