Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
81270B
1.REMOVE LICENSE PLATE LIGHT BULB
| *a | Insert in Hole |
|
Protective Tape |
|
Push in this Direction |
Insert a screwdriver into the hole of the license plate light lens.
Tape the screwdriver tip before use.
Slightly push the screwdriver in the direction indicated by the arrow shown in the illustration to widen the license plate light lens with the tip of the screwdriver to detach the claw.
Detach the remaining claw and remove the license plate light lens.
Remove the license plate light bulb.