Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC LIGHT CONTROL SENSOR
RM3270E _59 Vehicle Exterior _041720 LIGHTING (EXT) _0199684 AUTOMATIC LIGHT CONTROL SENSOR G

LIGHTING (EXT)  AUTOMATIC LIGHT CONTROL SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89120A 1.INSPECT AUTOMATIC LIGHT CONTROL SENSOR

a.
B157083C25
1.521,0.333 1.896,0.552 0.375,0.219 0.958,1.583 1.406,1.167 true 1.667,1.656 1.667,1.188 true 2.313,1.531 2,1.156 true 0.135,0.104 0.344,0.26 0.208,0.156 10 false *a 1.635,0.354 1.875,0.563 0.24,0.208 10 false H5 0.75,1.615 1.156,1.781 0.406,0.167 10 false CLTB 1.51,1.698 1.917,1.865 0.406,0.167 10 false CLTE 2.188,1.583 2.594,1.75 0.406,0.167 10 false CLTS
*a Front view of wire harness connector
(to Automatic Light Control Sensor)


Disconnect the automatic light control sensor connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H5-1 (CLTB) - H5-2 (CLTE) Engine switch off Below 1 V
Engine switch on (IG) 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
H5-2 (CLTE) - Body ground Always Below 1 Ω


If the result is not as specified, repair or replace the wire harness.


c.
E259758C26
1.531,0.271 1.927,0.49 0.396,0.219 1.833,1.177 2.042,0.823 2.042,0.823 2.333,0.823 true 1.458,1.167 0.969,1.167 true 0.188,0.135 0.438,0.313 0.25,0.177 10 false *a 1.646,0.292 1.844,0.448 0.198,0.156 10 false H5 0.573,1.073 0.99,1.25 0.417,0.177 10 false CLTS 2.396,0.729 2.813,0.927 0.417,0.198 10 false CLTE
*a Component with harness connected
(Automatic Light Control Sensor)


Reconnect the automatic light control sensor connector.


d.

Connect an oscilloscope to the automatic light control sensor connector.


e.
E276298N01
2.844,1.646 3.219,1.813 0.375,0.167 10 false GND

Check the waveform.

OK:
Tester Connection Tool Setting Condition Specified Condition
H5-4 (CLTS) - H5-2 (CLTE) 2 V/DIV., 10 ms./DIV. Ignition switch on (IG), light control switch in AUTO position Correct waveform is as shown


HINT:

The communication waveform changes according to the surrounding brightness.


If the result is not as specified, replace the automatic light control sensor.