Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM3270E _59 Vehicle Exterior _041720 LIGHTING (EXT) _0199685 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear height control sensor sub-assembly installation/removal are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link
Work that changes the vehicle height such as replacement or removal/installation of the rear height control sensor sub-assembly LH or replacement of suspension components Headlight leveling ECU assembly initialization Automatic headlight beam level control system (Click here)

PROCEDURE

Hide 89408C 1.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

a.
E319912

Disconnect the connector.


b.
E319914

Remove the nut and disconnect the link rod.


c.
E319913

Remove the 2 bolts and rear height control sensor sub-assembly LH.

NOTICE:

If the rear height control sensor sub-assembly LH has been dropped, replace it with a new one.