88645H
1.INSPECT NO. 1 PRESSURE SWITCH
Disconnect the connector.
| *a | Front view of wire harness connector
(No. 1 Pressure Switch) |
Using a service wire, connect terminals 1 (S+) and 2 (S-) of the No. 1 pressure switch connector on the vehicle wire harness side.
Start the engine.
Turn the A/C switch on and check that the magnet clutch turns on.
Check that the magnet clutch turns off when disconnecting terminals 1 (S+) and 2 (S-).
| Measurement Condition | Specified Condition |
|---|---|
| Terminals 1 (S+) and 2 (S-) connected | Magnet clutch turns on |
| Terminals 1 (S+) and 2 (S-) disconnected | Magnet clutch turns off |
If the result is not as specified, replace the No. 1 pressure switch.