84453
1.INSPECT IDLE UP SWITCH
| *a | Component without harness connected
(Idle Up Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 - 3 | Idle up switch ON position | Below 10 Ω |
| Idle up switch OFF position | 10 kΩ or higher |
If the result is not as specified, replace the idle up switch.
| *a | Component without harness connected
(Idle Up Switch) |
Check that the LED illuminates.
Apply battery voltage to the heater switch assembly and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 5
Battery negative (-) → 4 |
Idle up switch illuminates |
If the result is not as specified, replace the idle up switch.