Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the battery voltage.
11 to 14 V
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
Disconnect the C60 and C61 4 wheel drive control ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C60-21 (+B) - Body ground | Always | 11 to 14 V |
| C61-4 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the ignition switch off.
Disconnect the C61 4 wheel drive control ECU connector.
| *a | Front view of wire harness connector
(to 4 Wheel Drive Control ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| C61-10 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG