84970
1.INSPECT COMBINATION SWITCH ASSEMBLY (INTELLIGENT MANUAL TRANSMISSION SWITCH)
| *a | Component without harness connected
(Combination Switch Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (S) - 2 (E) | iMT switch pushed and hold | Below 1 Ω |
| 6 (S) - 2 (E) | iMT switch not pushed | 10 kΩ or higher |
| 4 (ECU) - 2 (E) | ECO mode switch pushed and hold | Below 1 Ω |
| 4 (ECU) - 2 (E) | ECO mode switch not pushed | 10 kΩ or higher |
| 3 (PWR) - 2 (E) | POWER mode switch pushed and hold | Below 1 Ω |
| 3 (PWR) - 2 (E) | POWER mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the combination switch assembly.
| *a | Component without harness connected
(Combination Switch Assembly) |
Apply battery voltage between the terminals of the switch, and check the illumination condition of the combination switch assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 5 (ILL+)
Battery negative (-) → 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the combination switch assembly.