Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY
RM3270E _55 Steering _041697 STEERING COLUMN _0201966 STEERING COLUMN ASSEMBLY A

STEERING COLUMN  STEERING COLUMN ASSEMBLY  REASSEMBLY  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 45020B 1.INSTALL STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY (for Smart Entry and Start System)

HINT:

When replacing the steering lock actuator assembly, refer to the Service Bulletin.


a.
C322179

Install the steering lock actuator assembly with the tapered-head bolt.


b.

Tighten the tapered-head bolt until the bolt head breaks off.


Hide 85432 2.INSTALL KEY INTERLOCK SOLENOID (for Automatic Transmission)

a.
C324271

Install the key interlock solenoid to the steering column upper with switch bracket with the screw.


Hide 84450 3.INSTALL IGNITION OR STARTER SWITCH ASSEMBLY

Hide 84052 4.INSTALL UN-LOCK WARNING SWITCH ASSEMBLY

Hide 69057A 5.INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY

a.

Make sure that the ignition switch lock cylinder assembly is in the ACC position.


b.

Install the ignition switch lock cylinder assembly.


Hide 6.INSPECT STEERING LOCK OPERATION

a.

Check that the steering lock mechanism is activated when the key is removed.


b.

Check that the steering lock mechanism is deactivated when the key is inserted and turned to the ACC position.

If there is any abnormality, replace the ignition switch lock cylinder assembly.


Hide 45020B 7.INSTALL STEERING LOCK ACTUATOR OR UPPER BRACKET ASSEMBLY

a.
C322178

Install the steering column upper with switch bracket assembly with the tapered-head bolt.


b.

Tighten the tapered-head bolt until the bolt head breaks off.


Hide 45206A 9.INSTALL STEERING SLIDING WITH COUPLING YOKE SUB-ASSEMBLY

a.
C324273C01
1.625,1.063 1.021,0.76 1.021,0.76 1.74,1.01 false 0.833,0.646 1.146,0.802 0.313,0.156 10 false *a
*a Matchmark


Align the matchmarks on the steering sliding with coupling yoke sub-assembly and steering main shaft.


b.

Install the steering sliding with coupling yoke with the bolt.

Torque:
35 N*m (357 kgf*cm, 26 ft.*lbf)