31410
1.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
Install 2 new gaskets, the master cylinder bracket and the clutch master cylinder assembly with the 2 nuts.
2.CONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
31481
3.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
| *A | w/o Intelligent Manual Transmission |
| *B | w/ Intelligent Manual Transmission |
| *a | Torque Wrench Fulcrum Length |
Using a union nut wrench, connect the clutch master cylinder to flexible hose tube.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)): 13.4 N*m (137 kgf*cm, 10 ft.*lbf)
31434
4.CONNECT CLUTCH RESERVOIR TUBE
Connect the clutch reservoir tube to the clutch master cylinder assembly, and slide the clip to secure it.
Connect the clutch reservoir hose so that it is not twisted.
5.CONNECT INTELLIGENT MANUAL TRANSMISSION CONNECTOR (w/ Intelligent Manual Transmission)
Connect the intelligent manual transmission connector to the clutch master cylinder assembly.
6.BLEED CLUTCH PIPE LINE
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING
7.CHECK FOR CLUTCH FLUID LEAKAGE
Check for leaks in the clutch system.
31301
8.INSPECT AND ADJUST CLUTCH PEDAL ASSEMBLY
9.CHECK FLUID LEVEL IN RESERVOIR
Click hereDrivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING