Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY(for Power Seat) › 2015.08–2016.01
RM3270E _58 Vehicle Interior _041711 SEAT _0203008 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

If the front seat side airbag was deployed, replace the front seat airbag assembly, separate type front seatback frame sub-assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.

·

Replace any other damaged parts as necessary.



PROCEDURE

Hide 1. PRECAUTION

CAUTION:
B394719

Be sure to read Precaution thoroughly before servicing.

AIRBAG SYSTEM:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(for Type B)>PRECAUTION


NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 72137J 2.REMOVE FRONT SEAT REAR OUTER TRACK COVER RH

a.

Operate the power seat switch knob RH (for Slide) to slide the front seat assembly RH to the frontmost position.


b.
B417335C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


While lifting up the part in the removal direction (1) shown in the illustration, detach the claw.


c.

Pull out removal direction (2) shown in the illustration to detach the guide and remove the front seat rear outer track cover RH.


Hide 72137K 3.REMOVE FRONT SEAT REAR INNER TRACK COVER RH

a.
B417336C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


While lifting up the part in the removal direction (1) shown in the illustration, detach the claw.


b.

Pull out removal direction (2) shown in the illustration to detach the guide and remove the front seat rear inner track cover RH.


Hide 4.REMOVE FRONT SEAT ASSEMBLY RH

a.
B403797

Remove the 2 bolts on the rear side of the front seat assembly RH.


b.

Operate the power seat switch knob RH (for Slide) to slide the front seat assembly RH to the rearmost position.


c.
B403799

Remove the 2 bolts.


d.

Operate the power seat switch knob RH (for Slide) to slide the front seat assembly RH to the center position.


e.

Operate the power seat switch knob RH (for Vertical) to set the seat cushion height of the front seat assembly RH to the uppermost position.


f.

Operate the power seat switch knob RH (for Reclining) to set the seatback of the front seat assembly RH to the perpendicular position.


g.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:
B394718

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.



NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



h.

w/ Front Seat Side Airbag:

Disconnect the front seat airbag assembly RH connector.

i.

Push the slider to detach the primary lock. Continue pushing and slide the slider to detach the secondary lock and then disconnect the airbag connector.

B273982C12
3.573,1.281 4.156,0.865 false 4.198,0.792 4.417,1 0.219,0.208 10 false *1 2.833,0.51 3.083,0.667 0.25,0.156 10 false *b 0.688,0.5 0.917,0.698 0.229,0.198 10 false *a
*1 Slider - -
*a Push *b Slide




i.
B403805

Disconnect the 2 connectors.


j.

Detach the wire harness clamp.


k.
B403812

Remove the front seat assembly RH as shown in the illustration.

NOTICE:
·

Protect the front seat legs.


·

Do not damage the front seat assembly RH, body exterior or interior parts.