Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY
RM3270E _58 Vehicle Interior _041711 SEAT _0203011 REAR NO. 2 SEAT ASSEMBLY A

SEAT  REAR NO. 2 SEAT ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·
B394717

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

There is risk of injury.

·

Replace any other damaged parts as necessary.



HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the RH side.



PROCEDURE

Hide 1.INSTALL REAR NO. 2 SEAT ASSEMBLY RH

a.
B402165C01
3.052,1.5 2.896,0.865 true 2.969,1.573 3.188,1.75 0.219,0.177 10 true *1
*1 Location Pin


Insert the location pin of the outer side into the hole in the body to lock the rear No. 2 seat leg assembly RH to the floor striker.

NOTICE:
·

Protect the front seat legs.


·

Do not damage the rear No. 2 seat assembly RH, body exterior or interior parts.



HINT:

Install the part with the seatback folded forward.



b.

Install the 2 pop-up prevention bolts.


c.
B402164N01
2.677,0.375 2.896,0.594 0.219,0.219 10 true (1) 0.979,0.333 1.198,0.552 0.219,0.219 10 true (2) 0.188,0.917 0.406,1.135 0.219,0.219 10 true (3)

Tighten the 3 bolts in the order shown in the illustration to install the rear No. 2 seat assembly RH.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


d.

Remove the 2 pop-up prevention bolts.


Hide 71848D 2.INSTALL SEAT ADJUSTER COVER CAP RH

a.
B402163C01
0,0 0,0 false
V113147

Install in this Direction


Push as shown in the illustration to attach the claw and guide and install the seat adjuster cover cap RH.


Hide 72927 3.INSTALL REAR SEAT CUSHION UNDER COVER RH

a.
B402161C01
0,0 0,0 false
V113147

Install in this Direction


Set the rear No. 2 seat assembly RH to the upright position.


b.

Push as shown in the illustration to attach the clip and install the rear seat cushion under cover RH.


c.
B402159

Install the 2 hole plugs.


d.

Lock the rear No. 2 seat leg assembly RH to the floor striker and set the rear No. 2 seat to the upright position.


Hide 71940E 4.INSTALL NO.2 SEAT HEADREST ASSEMBLY

a.
B404747C01
0,0 0,0 false
V100136

Apply silicon
V100155

Lubricant in this range.


Apply silicon lubricant at the positions shown in the illustration and install the No. 2 seat headrest assembly.