| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | Both conditions are met:
·
The voltage at the IG power supply terminal of the combination meter assembly is between 11.5 V or higher. ·
No communication with the ECM continues for 2 seconds or more. |
·
ECM ·
CAN communication system ·
Combination meter assembly |
| U0129 | Lost Communication with Brake System Control Module | Both conditions are met:
·
The voltage at the IG power supply terminal of the combination meter assembly is between 11.5 V or higher. ·
No communication with the brake actuator assembly (skid control ECU) continues for 3 seconds or more. |
·
Brake actuator assembly (skid control ECU) ·
CAN communication system ·
Combination meter assembly |
| U0151 | Lost Communication with Restraints Control Module | Both conditions are met:
·
The voltage at the IG power supply terminal of the combination meter assembly is between 11.5 V or higher. ·
No communication with the airbag sensor assembly continues for 10 seconds or more. |
·
Airbag sensor assembly ·
CAN communication system ·
Combination meter assembly |
Clear the DTCs.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check that no DTCs are output.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR
U0100, U0129 and U0151 are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG