Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
52119A
1.REMOVE FRONT BUMPER COVER
75602A
2.REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH
When removing the front fender moulding sub-assembly LH, heat the vehicle body and front fender moulding sub-assembly LH using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Front Fender Moulding Sub-assembly LH | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts.
Touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
|
Protective Tape |
Put protective tape around the front fender moulding sub-assembly LH.
Remove the 3 clips.
Remove the 2 screws.
Detach the clip and double-sided tape to remove the front fender moulding sub-assembly LH as shown in the illustration.
| *a | Double-sided Tape | - | - |
|
Order of Removal |
|
Place Hands Here |
|
Remove in this Direction | - | - |