Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › ACCELERATOR PEDAL
RM3270E _51 Engine / Hybrid System _041671 1GD-FTV ENGINE CONTROL _0203618 ACCELERATOR PEDAL G

1GD-FTV ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

Powertrain > Engine > Data List
Tester Display
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
50003 234 15,16

e.

Operate the accelerator pedal sensor assembly and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.

Standard Voltage (Accel Sens. No.1 Volt %):
Accelerator Pedal Condition Specified Condition
Released 10 to 22%
Depressed 52 to 90%


Standard Voltage (Accel Sens. No.2 Volt %):
Accelerator Pedal Condition Specified Condition
Released 24 to 40%
Depressed 68 to 99%


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness or ECM.