Home › Engine / Hybrid System › 1GD-FTV ENGINE CONTROL › MASS AIR FLOW METER › 2015.08–2016.01
RM3270E _51 Engine / Hybrid System _041671 1GD-FTV ENGINE CONTROL _0203619 MASS AIR FLOW METER G

1GD-FTV ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT INTAKE MASS AIR FLOW METER SUB-ASSEMBLY

a.

Read the value using the GTS (MAF).

NOTICE:

Perform the inspection of the intake mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).


i.

Connect the GTS to the DLC3.


ii.

Start the engine.


iii.

Turn the GTS on.


iv.

Enter the following menus: Powertrain / Engine / Data List / MAF.

Powertrain > Engine > Data List
Tester Display
MAF
50003 234 3

v.

Wait for 30 seconds, and read the value on the GTS.

Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>ECD SYSTEM(w/ DPF)>DATA LIST / ACTIVE TEST

If the result is not as specified, replace the intake mass air flow meter sub-assembly.

If the result is within the specified range, inspect the intake mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>1GD-FTV ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION